logo

Maxcover

maxcover

Maxcover is an angular trapezoidal profile with box crests and valleys suitable for
roofing and wall cladding. It is especially targeted at domestic and light industrial /
commercial applications where the goal is economy and aesthetics.

  • Maxcover offers the widest cover width in Uganda.
  • Maxcover has 5 troughs and 6 ribs. The valley (trough) is wider than the crest (rib)
    and stiffened using three 21 mm wide strips.
  • Maxcover can be factory cranked into curves of minimum 400 mm radius to enhance
    its use and aesthetic properties.

PROFILE MAXCOVER

prof

TECHNICAL SPECIFICATION

specs

ISOMETRIC VIEW

guage

FIXING PROCEDURE
Lay each run of sheets in turn from bottom to
top before moving onto the next run as depicted
below. Similar procedure for wall cladding too.

INSTALLATION
The recommended roof fitting method for Covermax and Maxcover is as shown in the figure below.

installation

No of sheets calculation of standard 3 mtr length = Area to be covered
(3 x effective cover width of the sheet)

RECOMMENDED ENDLAPS
endlaps

MAXIMUM PURLIN SPACINGS

This recommendation to be taken as a guide only. A Structural Engineer should determine precise figures.

spacing
direction

PRODUCT FEATURES

features